Saw Assembly
Mounting Bolts
– Front and rear
Attach the Saw to the floor stand
Place the saw onto the floor stand and align the
four holes in the corners of the base with the
holes in the top of the stand.
Use four M6 x 25mm hex head bolts, plain
washers and nuts, attach the saw to the leg
stand.
Please note
–
Do not over tighten these bolts
as this would damage the saw base.
Attach the left-hand extension table
Use three M6 x 16mm bolts, with a spring
washer and a plain washer.
Pass the bolt through the extension table and
into the threaded hole in the main table.
Ensure that the table and extension are level
before tightening.
NOTE:
the hole in the end of the extension
must be positioned at the front of the saw.
Attach the two table supporting braces.
Use an M6 x 16 bolt, washer & nut to attach the
upper end of each brace to the extension table.
Then repeat for the lower end of the brace.
The nuts for the lower end are retained in a
recess moulded into the inside of the saw base.
Before tightening the bolts, use a straight edge
to level the extension with main table.
Repeat the procedure to assemble the
right-hand table extension.
Inside view of lower fixing bolt
