11
MATCH LIGHTING THE SEAR BURNER:
1. Open the lid of your grill before lighting.
2. Make sure the control knob is in the "OFF" position.
3. Place a paper match in the end of the matchlighter. Strike and
carefully place a match approximately 1/2" (1 to 2 cm) from the
sear burner element.
4. Turn the sear burner control knob to the "HIGH" position. The
burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and
wait 5 minutes for gas to dissipate and repeat lighting procedure.
6. If the burner does not light within the first few attempts of match
lighting, there is a problem with the gas supply. Turn off the gas at the burner
and
cylinder.
DO NOT
attempt to operate the sear burner until the problem is found and corrected. See "Trouble Shooting"
section of this manual.
LIGHTING THE ROTISSERIE BURNER:
1. Open grill hood before lighting rotisserie burner.
2. Make sure control knob is in the "OFF" position.
3. Push and turn the control knob to the "HIGH" position.
Continue to push in control knob while pressing electronic
igniter for 3 – 5 seconds.
4. Once burner is lit, continue to push and hold control
knob for 30 seconds.
5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF”, wait 5 minutes to allow gas to
dissipate and repeat lighting procedure.
6. To turn off, turn control knob clockwise until it locks in the "OFF" position.
IMPORTANT:
DO NOT use back rotisserie burner when main burners are in use.
Note:
If burner does not light or flame is too low, you may have spider or other insect blockage in
burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance"
under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting
LP Cylinder and Hose/Regulator to Grill.
MATCH LIGHTING THE ROTISSERIE BURNER:
1. Open grill hood before lighting rotisserie burner.
2. Make sure control knob is in the "OFF" position.
3. Strike and carefully place a match approximately
1/2" (1 to 2 cm) from the lower edge of burner.
4. Push and turn the control knob to the "HIGH" position.
Continue to push in control knob for 3 – 5 seconds while
holding a match under burner. The burner should light
within 5 seconds.
5. Once burner is lit, continue to push and hold control knob for 30 seconds.
6. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and
repeat lighting procedure.
7. If the burner does not light within the first few attempts of match lighting, there is a problem with the
gas supply. Turn off the gas at the burner and cylinder.
DO NOT
attempt to operate the grill until the
problem is found and corrected. See "Trouble Shooting" section of this manual.
Match
