7
Packing instructions
Before packing, the reserve should be visibly inspected by the packer. The reserve must then be aired over a
period of 24 hours by an air humidity of 60 – 65 %. Packing should at best be carried out on a packing table,
but at the least on a clean, antistatic underlay. Necessary aids to packing are : 2 meters of draw cord, several
small sacks filled with sand or lead shot for weighing down. All special rubber bands must be renewed at every
repacking, and these are available by Charly Products.
The reserve should only be packed by a registered packer.
1. Laying out and unravelling
The reserve is stretched out to its full length on the packing underlay.
1.1.
Inspect the middle apex for symmetry
1.2.
Pull a draw cord through the packing loops and attach to
the upper end of the packing table:
1.4.
The bridle line is fixed to the lower end of the packing table
and the reserve is stretched. The suspension lines are
checked to ensure that their course is straight.
1.3.
Check the loops of the suspension lines on the end of the
bridle, and ensure that these are centred.
