Charlton & Jenrick infinity 890 BF, Owner'S Manual, Page: 6 / 32

6 LT6541 (ISS 11)

The Appliance is for use on Natural Gas ( G20 @ 20mbar ) & L.P.G ( G31 @ 37mbar )

Failure to install appliance correctly could lead to prosecution.
In GB (Great Britain), the appliance must be installed by a competent person i.e. GAS SAFE registered, in accordance
with the GAS SAFETY (INSTALLATION AND USE) REGULATIONS, The Building Regulations (or The Building Regulations
(Scotland) or The Building Regulations (Northern Ireland)) and The Current I.E.E. Wiring Regulations, if appropriate.
In IE (Ireland), the appliance must be installed by a competent person and installed in accordance with the current
edition of I.S.813 Domestic Gas Installation, the current Building Regulations and the current ETCI rules for electrical
installation, if appropriate.

Although the INFINITY 890 BF is fitted with a glass front which acts as a dress guard it is strongly
recommended that a fireguard should be used for the protection of children, the elderly or infirm.
Fireguards should conform to B. S. 6539 (1984) (Fireguards for use with solid fuel appliance).

Care should be taken to prevent any damage being caused to surrounding soft furnishings or decoration.
Many wall coverings may become discoloured if placed too close to the appliance, it is strongly
recommended that any proposed wall covering intended for use immediately above the appliance should be
tested in the hottest position (immediately above) first. Run the fire on high over a few days

All combustible material must be removed from behind the fire and fire trim.

The first time you light your new appliance a smell may occur due to its new condition. This is quite normal
and will soon disappear after a few hours use at maximum setting (open a window until the smell
disappears)

With use the inside of the air box will change colour, particularly the sides and rear. This is quite normal and
often adds to the overall effects of the appliance.

The appliance MUST NOT be used if the glass panel is not correctly fitted or if this panel is cracked or
broken.

Any debris should be cleaned from the appliance. A vacuum cleaner can be used but only after all the loose
shapes have been removed.

Prior to removing or cleaning the coals refer to the ‘Health and Safety Notice’ located on page 3 of this
booklet.

The appliance should be serviced annually by a competent person i.e. a GAS SAFE registered engineer in
accordance with these instructions.

The glass or any part of the appliance MUST NOT be cleaned or wiped whilst the appliance is HOT, to do so
could be dangerous and may damage the paintwork of the appliance.