Megabeat Pro
WHAT’S NEW IN 2.3 O.S. RELEASE, AND NOTES ABOUT “PHONES” OUTPUT
_ Chapter 5/16 (manual revision 2) : LNKMOD
START BEAT changed into START MEAS
STOP BEAT changed into STOP MEAS
_In “UTILITY / MIDI SETUP” added “PRELOAD : enabled/disabled” option
_In “ADJUST” page / “GLOBAL VOLUME ADJUST”, when one track reaches maximum
level (127), global volume will be locked. The same when a track reached minimum level (0).
Nevertheless you can modify single volume track one by one.
_Filtered Roland “single/mode 1 mode” sysex message ( if present into midifile )
_Conformed lyrics visualization on display and TV connected via scart.
_Vocalizer enabled in play mode “USER “
About “PHONES” output :
Be careful in connecting to the "PHONES" jack output (headphones or else), stereo jacks
only. Those jacks must be connected to a stereo input.
The minimum impedance of the headphones must be 60 Ohm ( if you work with smaller
impedance heaphones, you may damage an inside component and, because of it, no signal will
be transmitted by jack "PHONES" output ).
If you need to connect devices provided with a mono input only (i.e. monitors), it is
recommended to use an insert cable adapter (stereo jack to two mono jacks) or a cable as
follows:
"CLICK" output (Mbeat Pro): Stereo jack (it will work with one of the channels: left or
right)
"CLICK" input (i.e. monitor): Mono jack (The cable can be mono)
©2000 Charlie Lab
All the trade marks are registered
Charlie Lab reserves the right to make changes both to hardware and to software without notice with the purpose to always make things
better.
In case differences are found between the current manual and the machine you own, please contact us.
5
