C6050A, C6050B
v2.0
High efficiency wide input voltage
PFC programmable Charger
90V~265VAC input
For 4S~15S LiPo/LiFe battery
1~55Amps 3050W max.
www.chargery.com
page
9
total
19
Remote control operation instructions
1.
Connect to AC source, turn on the charger
2.
After LCD initialize, the C6050 enter into idle model
3.
Connect battery to the charger. The battery voltage will be displayed, but it is not accurate, because
the charger can protect the battery from reverse polarity connection and anti spark.
4.
Connect the external device to the C6050, the EHR-2p wire is included with the charger.
5.
Press Knob enter into battery type interface, alternate battery type and press Knob, enter into
charge setup interface,
a)
Set up cell count,
b)
Set up charge current, it should be the maximal current that the battery can be charged, when
PWM failed, the charger will charge at this current.
c)
Set up end current, when the charge current under setup at CV, stop charging and the battery
fully charged, display KEEP charge status. The end current is a percentage (1-60%) of setup
current on last step. Such as the maximal current is 10A, end current is setup to 10%, the end
current is 1A.
d)
Set up end voltage, the voltage is cell voltage, it must be under or same as OVP on BMS. C6050
will charge at CV when total battery voltage reach cell count*setup value.
e)
On the charge mode, need not setup restart voltage.
8.
Press Knob for 3 seconds, the charger will start to charge, the charge current will be modified
according to the Duty cycle of PWM from external device. The higher Duty cycle, the higher current.
The current range is 1A-55A.
9.
Finish charge, the beeper sounds 10 times, charge current is zero, and display KEEP status. If need
to continue to charge, adjust duty cycle to under 3% then increase gradually to adjust charge
current.
10.
During charge, press Knob stop charging at any time.
Please watch the operation video on
https://youtu.be/KDD-QWLkFQc
