Dual Input Synchronous Balancer/Charger/Discharger
C4012B V1.24
www.chargery.com
page 12 total 18
Tips
1.
In main interface, press for 3 seconds, the charger will enter into function interface directly,
press for 3 seconds will operate last program directly.
2.
During charge in CC phase, the charge current can be set up to new value
and need not stop charging. On Cells and Info page, press Knob button for
3 seconds, Ch. Current modification window is pop up, please press Knob
and rotate Knob button modify charge current, press
Esc
quit and press
Ok
save the change. The charger will charge at new current.
And rotate Knob to alternate Cells, Info and IR label page, on Info page,
you will check some preset
parameters and actual input power.
On IR page, you can check each cell
impedance and total battery
impedance
3.
During discharge, the discharge terminal voltage can be changed and
need not stop discharging, On Cells and Info page, press Knob button for
3 seconds, Disch. End.Voltage modification window is pop up, please
press Knob and rotate Knob button modify end voltage per cell, press Esc
quit and press Ok save the change. The charger will continue to discharge
and stop at new terminal voltage.
4.
On LiTo, LiPo&Hv and LiFe battery balance charge program, Enable
“Charging Keep After Done”, continue to charge at smaller current when
charging is done. Disable the function, will stop really charging.
Original Charge current
charge
terminal
current
Shut
down
Temperature
Input
power
Charge
terminal
voltage
/
cell
