C10325A
v2.2, C10325B V2.2
High efficiency wide input voltage
PFC programmable Charger
90V~265VAC input
For 4S~24S LiPo/LiFe battery
1~25Amps 1500W max.
www.chargery.com
page
10
total
19
Program Setup
1.
In charger idle interface, press
knob
button for 2 seconds enter
into Program Setup menu.
2.
LCD display the following information in sequence and you can
modify its value. When you want to alter a parameter value, press
the
knob
button make the value blink then modify the value by
rotate the
button. The new value will be confirmed and saved by
pressing the button again.
3.
Press
knob
quit the setup menu.
Note:
All parameters will be remembered by the C10325A/B till next change.
Picture 3
Program setup
Setup the Temperature unit,
℃
or
℉,
default
℃
.
Temp. Unit
--->
℃
Setup the maximal charge current, range from 1A~25A, step 0.1A, default
25A. It is only active for power supply.
Max current
---> 60A
Setup the fan starting temperature, range from 30~50
℃
,
step 1
℃
,
default 35
℃
.
The fan speed will increase with the temperature go
up.
Fan ON Temp.
---> 40
℃
The beeper sounds for each button press to confirm your action. These
sounds can be ON or OFF. Default ON.
Buzzer
--->
ON
This menu sets the back-light time of LCD screen backlight.
Options:
1MIN, 5MIN, 10MIN, 20MIN and Always on, default 5MIN.
At
default 5min, LCD back-light will be off to save the power,
press
knob
resume the back-light.
BACK-LIGHT TIME
---> 5MIN
Setup over temperature protection, range from 70~110
℃
,
step 1
℃
,
default 110
℃
.
Over the temperature, the charger will power off
Shut Down Temp.
---> 80
℃
