Char-Griller Double Play 5650, Owner'S Manual

Page: 39 / 56

C-3 C-3
** BEFORE USE CHECK FOR LEAKS **
Never check for leaks with a naked eye. Always use a soapy water solution.
NOTE: Before starting the grill, check for leaks. Make sure the regulator valve is securely fastened to the
burner and the cylinder to prevent fi re or explosion hazard when testing for a leak. Always perform the
“Leak Test” as described below before lighting the grill or each time the cylinder is connected for use.
• Do not smoke or allow other sources of ignition in the area while conducting a leak test.
• Conduct leak test outdoors in a well-ventilated area.
• Do not use matches, lighters or a fl ame to check for leaks.
• Do not use grill until any and all leaks are corrected. If you are unable to stop a leak, disconnect the
propane supply. Call a gas appliance serviceman or your local propane gas supplier.
Leak Test
1. Mix 2-3 fl oz. of solution, 1 part dishwashing soap, 3 parts water.
2. Ensure control valve is closed.
3. Connect regulator to cylinder and valve to burner. Ensure connections are secure before turning on gas.
4. Spray solution on the tank valve to regulator connection, the “Y” joint in the hose, the connection to
the manifold behind the main control panel, and the connection to the side burner valve.
5. Inspect the solution at the connection looking for bubbles. If NO bubbles appear, the connection is
secure. If bubbles appear, you have a leak.
6. Disconnect regulator from the tank and reconnect, making sure the connection is secure.
7. Retest
after fi xing leak. If you continue to see bubbles, replace the cylinder.
8. Turn gas off after testing.
Lighting Instructions
Always open hood while igniting grill. If grill does not light, always wait 5 minutes for gas to clear before
relighting. Failure to do either may result in an explosive fl are-up, which can cause serious bodily
injury or death. Once lit, but before cooking on grill for fi rst time, let grill sit for 15 minutes with hood
closed. This heat cleans grill’s internal parts from anything they may have come into contact with during
manufacturing and shipping.
Main Burners
1. Make sure there are no obstructions of airfl ow to gas unit. Spiders and
insects can nest within and clog the burner tube. A clogged burner tube
can lead to a fi re beneath appliance.
2. Make sure all burner knobs are in OFF position.
3. Open valve on LP gas cylinder.
4. Push in and rotate knob slowly, about ¼ turn, until a click is heard. If
burner does not light in 5 seconds, turn burner OFF, wait 5 minutes for
gas to clear and repeat procedure. Repeat for all desired burners. Light
only burners intended for use.
5. Adjust knobs to desired cooking setting.