10 • 463233503
5. Hold regulator, insert nipple (B) into LP tank valve.
Hand tighten coupling nut, holding regulator in a
straight line (C) with LP tank valve so as not to cross
thread the connection.
6. Turn the coupling nut clockwise to tighten to a full solid stop.
The regulator will seal on the back-check feature in LP tank
valve, resulting in some resistance. An additional one-half
to three quarters turn is required to complete
connection. Tighten by hand only - do not use tools.
NOTE: If you cannot complete connection, disconnect regulator and
repeat steps 5 and 6. If you are still unable to complete the
connection, do not use this regulator!
Hold coupling nut
and regulator as
shown for proper
connection to LP
tank valve.
Nipple has to be
centered into the
LP tank valve
• Do not insert any foreign objects into the valve
outlet. You may damage the valve and cause a leak.
Leaking propane may result in explosion, fire, severe
personal injury, or death.
• Never attempt to attach this grill to the self-contained
LP gas system of a camper trailer or motor home.
• Do not use grill until leak checked.
• If leak is detected at any time, STOP and call the Fire
Department.
• If you cannot stop a gas leak, immediately close LP
tank valve and call LP gas supplier or your fire
department!
WARNING
WARNING
WARNING
WARNING
WARNING
B
B
B
B
B
C
C
C
C
C
Use of this POL transport plug
(A) (plastic part with external
threads) will defeat safety
feature of valve.
A
A
A
A
A
LP Tank Leak Test
For your safety
• Leak test must be repeated each time LP tank is exchanged or
refilled.
• Do not smoke during leak test.
• Do not use an open flame to check for gas leaks.
• Grill must be leak checked outdoors in well-ventilated area, away
from ignition sources such as gas fired or electrical appliances.
During leak test, keep grill away from open flames or sparks.
Use a clean paint brush and 50/50 soap and water
solution. Use mild soap and water.
▲
▲
▲
▲
▲
Do not use household cleaning agents.
Damage to gas train components can result.
Brush soapy solution
onto the shaded areas.
Connecting The Regulator To The LP Tank
OPD Hand
Wheel
Type 1 outlet with thread on outside
1. LP tank must be properly secured onto grill.
2. Turn all control knobs including sideburner (if featured) to the OFF
position.
3. Turn LP tank OFF by turning hand-wheel
clockwise to a full stop.
4. Remove the protective cap from
LP tank valve. Always use cap and
strap supplied with valve.
Strap and Cap
Safety Relief Valve
O f f
Clockwise
If
"growing"
bubbles appear
do not use or move
the LP tank. Contact
an LP gas supplier or
your fire department!
