Char-Broil PERFORMANCE IR Series, Operating Instructions Manual

Page: 5 / 128

5 GB
1. Turn gas burner control valves to (off).
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
4. To ignite, push and turn burner knob to
HIGH.
Immediately, push and hold ELECTRONIC
IGNITOR button until the burner lights.
5. If ignition does NOT occur in 5 seconds, turn the
burner controls off , wait 5 minutes and repeat
the lighting procedure.
6. Repeat steps 4 and 5 to light other main burners.
WARNING
Turn controls and gas cylinder off when not in
use.
CAUTION
If ignition does NOT occur in 5 seconds, turn
the burner controls off, wait 5 minutes and
repeat the lighting procedure. If the burner
does not ignite with the valve open, gas will
continue to flow out of the burner and could
accidently ignite with risk of injury.
Match-Lighting
•
Do not lean over barbecue while lighting.
1. Turn gas burner control valves to (off).
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
4. Place match into match holder (hanging from
side panel of barbecue). Light match; then light
burner by placing match through the match light
hole on side of barbecue. Immediately
push in
and turn burner knob to the HIGH position.
Be sure burner lights and stays lit.
5. Light adjacent burners in sequence by pushing
knobs in and
NOTE: Your barbecue may NOT be
equipped with a Hot plate!
Hot plate Ignitor Lighting
•
Do not lean over barbecue while lighting.
1. Turn gas burner control valves to (off).
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
4. Turn hot plate knob to the HIGH position,
push and hold ELECTRONIC IGNITOR button.
5. If hot plate does NOT light within 5 seconds, turn
knob to (off), wait 5 minutes, then repeat
lighting procedure.
Hot plate Match Lighting
•
Do not lean over barbecue while lighting.
1. Turn gas burner control valves to (off).
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
4. Place lit match near burner. Immediately turn
hot plate knob
Leak Testing Valves, Hose and
Regulator
Leak test before first use, at least once a year, and
every time the cylinder is changed or
disconnected.
1. Turn all appliance control knobs to .