7
17
Insert flange on right side shelf into side shelf brackets on side of firebox, shown
A
.
Attach rear of shelf using one
1/4-20x3/4”
screw,
7mm
lock washer,
7mm
washer and
1/4”
nut in upper hole; using one
flat
1/4-20x1½”
screw,
7mm
lock washer and
7mm
flat washer in lower hole, shown
B/C
.
two
Attach front of shelf and fascia using
1/4-20x3/4”
C/D/E.
screws,
7mm
flat washers,
#8x3/8”
self-tapping screw with large flat washer, shown
7mm
lock washers and
1/4”
nuts, and one
1/4-20x1½” screw
1/4-20x3/4” screw
7mm lock
washer
7mm lock
1/4”nut
1/4”nut
washer
7mm lock
washer
7mm flat
washer
7mm flat
washer
7mm flat
washer
1/4-20x3/4” screw
Note: Insert this screw from
the back of main control
E
#8x3/8” tapping
screw
large flat
washer
Rear of Shelf
Back of main control panel
1/4-20x3/4”
Igniter Switch
screw
7mm lock
washer
7mm flat
washer
1/4”nut
D
panel
Remove the four screws and washers factory attached to the Auto Clean valve bracket. Position Auto Clean valve bracket
beneath right side shelf fascia so that valve stem comes through larger center hole in fascia. Align the four holes on valve
bracket with the four holes on fascia. Secure using screws and washers that were removed from bracket, shown
F
.
Place the blank bezel over valve stem on front side of the fascia. Align small holes on bezel with the holes on fascia.
Attach using two
#8-32x3/8”
screws and
4mm
lock washers. Press control knob on to valve stem, shown
G
.
Screws and Washers
removed from valve bracket
Auto Clean
valve bracket
valve stem
valve stem
bezel(blank)
knob
F
#8-32x3/8” screw
4mm lock
washer
G
C
B
A
Summary of Contents for 463271310
Page 30: ...NOTES 30 ...
Page 31: ...Warranty Registration Department P O Box 1240 Columbus GA 31902 1240 31 ...
Page 32: ......
