9
24
Pull out the three knobs from control panel. Insert temperature gauge stem into the biger hole above knob bezel,shown
A
.
Make the temperature gauge attached on the panel. Push the temperature gauge downward till it clips on the panel,
shown
B/C
. Re-install the three knobs.
Knob
Knob bezel
Temperature gauge
Temperature gauge stem
Control panel
A
C
B
Back of the panel
8
First, remove the two screws and lock washers factory attached to the sideburner valve bracket.
Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia. Attach using two
#8-32x3/8”
screws and
4mm
lock washers. Press sideburner control knob onto valve stem.
Control knob
Control knob bezel
Install bezel with “OFF” at top.
Sideburner
valve bracket
Screws and Washers
removed from valve bracket
Valve stem
#8-32x3/8” screw
4mm
lock washer
Sideburner
fascia
Note: Use left and right
holes on fascia to
attach valve bracket
Note: Use upper and lower
holes on fascia to
attach bezel
17
