7
Insert flange on right side shelf into side shelf brackets on side of firebox, shown
C
.
Remove the three screws and washers which were attached on right side of firebox front, shown
B
.
Attach rear of shelf using one
1/4-20x3/4”
screw,
7mm
lock washer, fiber washer and
1/4”
nut, shown
E/F
.
Attach right side shelf front using the two screws and washers which were removed from right side of fire box, shown
D
.
C
Side shelf
Right side shelf
B
remove
5mm lock washer
5mm flat washer
#10x3/8” screw
A
Right side lower fascia (inside)
Inside of right side shelf
washers, shown
A
.
Attach right side lower fascia to right side upper fascia using three
#10x3/8”
screws,
5mm
lock washers and
5mm
flat
bracket
G
Screws and Washers
removed from valve bracket
Note: Use upper and lower
holes on fascia to
attach bezel
Auto Clean valve bracket
Valve stem
Bezel (blank)
#8-32x3/8”
4mm
lock washer
Valve stem
Control knob
Remove the four screws and washers factory attached to the Auto Clean valve bracket. Position Auto Clean valve bracket
beneath right side shelf fascia so that valve stem comes through larger center hole in fascia. Align the four holes on valve
bracket with the four holes on fascia. Secure using screws and washers that were removed from bracket, shown
G
.
Place the blank bezel over valve stem on front side of the fascia. Align small holes on bezel with the holes on fascia.
Attach using two
#8-32x3/8”
screws and
4mm
lock washers. Press control knob on to valve stem, shown
H
.
H
screw
D
Screw
Washer
*Screws and washers
removed from right
side of firebox front.
E
1/4-20x3/4”
Screw
Fiber washer
Pliers needed
F
1/4” Nut
Washer
7mm lock
19
