12
Inside of cart, insert rear shield tabs into slots next to grease tray opening on upper back panel, shown
A
.
Attach front shield tabs(with holes) under front brace with two
#8x3/8”
self-tapping screws, shown
B
.
Tank heat shield
Cart lower back panel
Front Brace
#8x3/8”
#8x3/8”
self-tapping screw
self-tapping screw
Qty.2
for clarity of illustration
Note: some parts omitted
B
Upper back panel
Grease tray opening
rear tab
front tab
(w/hole)
Rear
Front
Tank heat shield
A
13
23
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module. Total (5) connections, shown
A
.
Connect the two wires [(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).
Total (2) connections, shown
A
.
ignition module
Electronic
Heat shield
Left side panel
B
C
Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart left
side panel with the nut, shown
B
.
Insert AA battery into ignition module, negative (
-
) end first. Then put on the cap, shown
C
.
Nut
-
+
AA battery
Cap
3
1
2
4
5
(a)
(b)
ignition module
Electronic
A
Summary of Contents for 463265109
Page 30: ...NOTES 30...
Page 31: ...31 Warranty Registration Department P O Box 1240 Columbus GA 31902 1240...
Page 32: ......
