Char-Broil 13201597, Product Manual, Page: 14 / 24

14
4
3
• Place Control Panel Assembly onto Smoker Chamber by placing tabs under the front edge of the Smoker Chamber. The
Control valve must engage the burner venturi tube as shown A.
• From the inside of the Smoker Chamber, Install 2 #10-24x3/8” screws through the smoker chamber and through the
Control panel Tabs as shown. Thread 1 #10-24 Keps Nut onto each screw and tighten As shown B. Install 2 #10-24x3/8”
screws through the control panel tabs and into the burner assembly housing. Thread 1 #10-24 Keps Nut onto each screw
and tighten securely. Shown B
Qty: 4
#10-24 Keps Nut
Qty: 4
#10-24x3/8" Screw
B
#10-24x3/8"
Screws
Control Panel
Shown Installed
• Be sure the electrode wire exits the hole UNDER the venturi tube hole. DO NOT route the wire through the same hole as
the burner venturi tube.
• Install Ignitor Wire by pushing the round connector onto the Ignitor as shown.
Install 1 #10-24x3/8"
Screw per side
Push the
Round end
of ignitor wire
onto the
Rotary Ignitor
Rotary ignitor
Control
Panel Tabs
Control Panel
Screw Hole
Control
Valve
A
Burner Assembly
Housing
#10-24 Keps Nuts