Channel Vision P-0920, Instructions Manual

Page: 9 / 12

Strike
Active
Ring
Intercom
Active
12VAC
#
o
r
*
N
o
C
O
Strike
Time
3
/5
r
n
g 1 2 3
Power Intercom Unlock
Door
Chime CO Input Phones
TELEPHONE ENTRY CONTROLLER
CO Input
Telephones
Model
P-0920
PRO
C
H A N N E L
TM
V
I S I O N
C
H A N N E L
V
I S I O N TM
User’s Guide
8
9
Using a traditional Door Chime
Basic Configuration:
Note: see the basic application page for details on switch settings.
Set the switch labeled “Key # - *” to determine which key will activate the
system.
Set the switch labeled “No CO” for the desired mode.
Set the switch labeled “Rings 3-5” to the desired distinctive ring pattern.
You can choose between a 3-ring or 5-ring pattern.
Set the switches labeled “Strike Time” to allow an electronic door release
to be activated for a specific period of time.
Basic Operation:
Note: The following instructions assume that the “Key * - #” switch is set
for “*” operation.
When the doorbell button is pressed, you will hear the distinctive ring
pattern selected above:
within 20 seconds - simply pick up the telephone to be connected to the
door speaker.
after 20 seconds - pick up the telephone and press “**” to be connected to
the door speaker.
To end communication with the door speaker, you can hang up the phone
or press “**”.
If you are already on the phone when the doorbell button is pressed you
will hear a call waiting tone. Simply press “**” to put your call on hold
while you are connected to the door speaker. Press “ **” to return to
your call.
To close the door strike relay while you are already communicating with
the door speaker, press “*7”.
To close the door strike relay when you are not communicating with the
door speaker, press “***7”.
To close the door strike relay without using a phone, you can use an
optional push button wired to the “Unlock Door” terminals (see “Using
the TE110DS Door Strike Relay” for details).
Door Plate
(IU-xxxx or DP-xxxx)
House
Telephones
12VAC
500mA
From Telephone
Service Provider
Doorbell Transformer
Doorbell Chime
If you would like the P-0920 to ring the phones and a traditional doorbell
chime, this can be easily done by following the diagram below. The wire
terminals labeled “Chime” are simply dry contacts that close whenever the
button on the door intercom is pressed. Wire any standard door chime to
these wire terminals as if the wire terminals were the actual doorbell
button. When the door intercom button is pressed these wire terminals will
short together and your doorbell chime will ring.