Channel Vision Aria A6600, Manual

Page: 7 / 36

The following procedure assumes that all rooms in the house, where remote controlled audio signals are desired,
have been pre-wired with home runs of 4-conductor cable and speaker wires. In addition, all IR receivers,
keypads, and speakers have been connected in each room, and the system is ready for installation of the ARIA.
CONNECTION PROCEDURE
CAUTION: Be sure no power is applied to any of the components until all connections are made.
Fig. 1 shows a typical installation of the ARIA A6600 utilizing 6 source inputs and 6 zone outputs.
1. Make line level connections from the audio output jacks on each of the audio source components to the appro-
priate SOURCE INPUT jack on the A6600. Use high quality audio RCA-type patch cords and make cable
length as short as possible to keep signal integrity intact.
2. Connect each ZONE AUDIO OUTPUT (Left and Right) to the appropriate channel or line input connector on
the power amplifier. (Refer to the instruction manual provided with your particular amplifier.)
3. Connect the speaker leads from each zone to the corresponding SPEAKERS terminals on the Power Amplifier.
Be sure zone speakers are connected to follow the zone outputs from ARIA.
4. Make connections from each zone’s wall keypad via the green 4-wire Euro-connectors to the rear of the
A6600. (Use 82-ohm resistors. See keypad installation)
5. Insert zone infrared emitters as desired into the zone emitter output jacks. Place emitter over the IR receiver
window of the equipment to be controlled.
6. Plug the power cord into a 120v AC outlet.
Note: The DIP switches on the rear panel are factory use only and do not normally require adjustment or setting
by the user.
INSTALLATION AND WIRING
5