EN
4
Use
1. Pull the power cable (14) completely up to the yellow mark, and insert the plug into the socket.
The yellow mark on the cable is before the end part of the cable marked in red.
NOTE
:
The accessories can be connected to the suction telescopic pipe (3) or directly to the
handle
(1).
NOTE
:
Do not pull the cable out to the red mark.
NOTE:
Using the vacuum cleaner with the cable fully or partly wound involves an overheating
hazard!
NOTE
:
A new appliance can develop odors the first few times it is used. These odors are
harmless and disappear shortly afterwards. Ventilate the room if needed.
2. Press the ON/Off button (8) once to switch the vacuum cleaner on [FIG. F1]. Adjust the suction
force with the electronic power regulator (7).
Minimum: for curtains, fine and delicate fabrics.
Average:
for standard cleaning, sofas, armchairs, upholstered chairs, rugs and carpets.
Maximum: for smooth floors.
3.
The suction power can also be changed with the manual adjusting device of the air flow (2)
found on the handle (1) [FIG. E1].
Closed:
Increases the suction power.
Open:
Reduces the suction power.
4. Switch off the vacuum cleaner by pressing the ON/Off button once (8) and unplug the power
cord (14) from the power socket.
5. Press the automatic cord winding button (15) to wind the power cable [FIG. F1]. Hold the plug
while winding the cable in order to prevent whiplash.
6.
Press the locking buttons of the flexible suction pipe (6) and disconnect the flexible suction pipe
(5) from the appliance.
7. Press the release button of the dust collection system (9) to extract the dust collection system
(16) from the appliance [G1].
8. Press the upper cover opening/locking button (16B) to open the upper cover (16A) [FIG. G2].
9. Empty the container.
10. Fit the upper cover back on (16A) ensuring the couplings with the dust container (16E) are per-
fectly engaged and the upper cover opening/locking button (16B) is perfectly engaged as well.
11. Fit the dust collection system (16) back onto the vacuum cleaner ensuring the position
ATTENTION
!
The vacuum cleaner has a motor protection thermostat, which intervenes in
the case of overheating (caused by the inlet opening, filters, etc. being
clogged). If it is triggered, press the ON/OFF (8) button to switch the appliance
off and let it cool down completely for a few hours. Verify whether dust has
clogged the filters or the inlet opening before restarting the appliance.
ATTENTION!
Switch the appliance off and disconnect the plug from the socket before
opening the appliance! Make sure all cleaned parts are completely dry before
reusing
the
appliance.
