REV 91050-20140620
20
91050
ENGLISH
6. Once the 7/16 screw, lock washer, and washer are
removed, the impeller (#29) can be removed from
the cam shaft of the engine.
7. Removing the impeller will make it easier to remove
and sharpen the shredder blade, flail blades, and
chipper blades.
8. To remove the shredder blade (#36), unscrew both
the M8x25 bolts (#33), washers ø8 (#14), lock
washers ø8 (#30) and M8 lock nuts (#35). (C)
MAINTENANCE AND STORAGE
Blade Sharpening Cont’d.
Blade Sharpening
Sharpening of the shredder blade, flail blades
and chipper blades are required maintenance to
be performed by a professional service center or
knowledgeable and experienced owners only. Sharpening
of the blades will keep the chipper-shredder performing
at a higher quality than with dull blades. Sharp blades
will chip or shred material faster and easier, and cause
the engine and other parts to work less. Blades are not
covered under warranty as they are a wear item, and
therefore should be sharpened regularly to keep their
edge and to ensure a longer life of the blades, other
parts and engine.
1. Make sure spark plug wire is disconnected.
2. Disconnect the recoil housing on the front of the
engine.
3. To get to the blades and impeller, the outer flail
housing assembly (#40) must be removed. The
steps in the flail housing and impeller cleaning
section should be followed to remove it and the
shredder screen (#60). (A)
A
9
37
38
39
B
29
36
14
30 35
33
C
26
27
28
29
D
34
35 30
14
33
E
4. Once the outer flail housing and shredder screen are
removed, remove the 7/16 screw (#39), 7/16 lock
washer (#38) and washer ø12 (#37) from the engine
cam shaft. (B)
5. DO NOT remove the flat key (#9) when removing the
screw, washers.
9. To remove the flail blades (#27), unscrew the M10
lock nut (#28) from the shoulder pin (#26). (D)
10. Repeat for all 4 flail blades.
11. To remove the chipper blade (#34), unscrew M8
lock nut (#35), lock washer ø8 (#30), washer ø8
(#14) from the M8x25 bolt (#33). Each chipper
blade is secured with two M8x25 bolts, lock washer,
washer and lock nut. (E)
12. Repeat for second chipper blade.
