9
REV 78021-20120120
ENGLISH
78021
OPERATION
Pressure Washer location
This pressure washer must have at least five feet of
clearance from combustible material . Leave at least
three feet of clearance on all sides of the pressure
washer to allow for adequate cooling, maintenance and
servicing . Place the pressure washer in a wellventilated
area . DO NOT place the pressure washer near vents
or intakes where exhaust fumes could be drawn into
occupied or confined spaces . Carefully consider wind and
air currents when positioning pressure washer .
before Starting the Engine
1 . Turn the water ON .
2 . Pull the trigger on the pressure gun to purge all
air from the pump and hose . This may take several
minutes .
3 . Do not start the engine until a steady stream of water
is flowing from the nozzle .
If the engine does not start after 2 pulls, relieve
pump pressure by pulling the trigger on the pressure
washer gun .
NOTE
If the engine starts but does not run make certain
that the pressure washer is on a flat, level surface .
The engine is equipped with a low oil sensor that will
prevent the engine from running when the oil level
falls below a critical threshold .
NOTE
Starting the Engine
1 . Make certain the pressure washer is on a flat, level
surface .
2 . Turn the Fuel Valve to the “ON” position .
3 . Move the choke lever to the “CHOKE” position .
Keep choke lever in “Choke” position for only 1
pull of the recoil starter . After first pull, move choke
lever to the “Run” position for up to the next 3
pulls of the recoil starter . Too much choke leads to
sparkplug fouling/engine flooding due to the lack of
incoming air . This will cause the engine not to start .
NOTE
4 . Pull the starter cord slowly until resistance is felt and
then pull rapidly
5 . Do not over-choke . As as soon as engine starts, move
the choke lever to the “RUN” position .
