Operation
12
Rev
76511-20090317
System Flush
After using detergents, flush the suction
system by placing the detergent suction tube
into a bucket of clean water.
WARNING
NEVER turn the water supply off before turning
the engine/motor off.
Depressurize System
To depressurize, turn engine/motor off, turn
water supply off and squeeze gun trigger 2-3
times.
WARNING
NEVER disconnect the high pressure discharge
hose from the machine while the system is
pressurized.
To reduce the risk of bodily injury or
property damage, always follow this
procedure whenever spraying is stopped,
when work is completed, and before
checking or repairing any part of the system.
1.
Engage the trigger safety latch.
2.
Turn the unit off.
3.
Remove the ignition cable from the
spark plug.
4.
Shut off the water supply.
5.
Disengage the trigger safety latch and
trigger the gun to relieve pressure.
6.
Re-engage the trigger safety latch.
7.
Before overnight storage, long term
storage, or transporting unit, disconnect
the water supply and turn off the fuel
supply valve.
Operating Tips
CAUTION
Never operate your pressure washer without
water.
CAUTION
Never connect your pressure washer to a hot
water supply.
Connecting your pressure washer to a hot water
source will significantly reduce the life of the
pump and will void your warranty.
CAUTION
Running the unit for more than one minute
without spraying water causes heat to build up in
the pump.
Running the unit without spraying water can
damage pump components and will void your
warranty.
CAUTION
Release the trigger prior to switching the wand
between high and low pressure.
Failure to do so may reduce the life of the o-rings
in the wand and will void your warranty.
Stopping the Engine
1.
Turn the engine switch to the “Off”
position.
2.
Move the fuel lever to the “Off” position
3.
Depressurize system.
4.
Turn off and unplug all hoses. Never
start or stop the pressure washer unless
the water supply is turned on.