5. Installation of right side hardware:
a. With thrower held up by the other side, insert Bushing (12) from inside out and hold trap in position.
(
Note
:
Wheel bearing grease or petroleum jelly can be used to keep the Bushing
(12)
in place during assembly. Use only
enough to hold it in place. Remove excess when step is complete.)
b. Once the trap is in position, install one 10mm Lock Washer (14) and one M10 Washer (16) onto the M10 x
25mm Socket Head Bolt (7) as shown.
c. Insert the M10 x 25mm Socket Head Bolt (7) with washers from previous step through the linkage bracket,
M10 Washer (16), Wobble Bird Base Sub-Assembly (1), Bushing (12) and into the Workhorse chassis as shown.
Do not tighten bolt completely
.
d. Slide the Large Washer (9) between the Workhorse trap chassis and the Wobble Bird Sub-Assembly (1)
ensuring it rests over the pressed in nut on the Workhorse Chassis.
e. Install one Bolt Cup, Small (10) onto the M10 Shoulder Bolt (6) as shown.
f. Insert the M10 Shoulder Bolt (6) with Bolt Cup, Small (10) from previous step through the linkage bracket,
M12 Washer (13), Wobble Bird Base Sub-Assembly (1), Large Washer (9) and into the Workhorse Trap chassis
as shown.
g. Tighten all four mounting bolts completely using the provided 8mm hex key.
6. See
page 16
for Wobble Bird Operation.
WARNING: Failure to tighten these bolts and to follow all instructions carefully can result in serious injury
or death.
Assembly of Workhorse Trap onto Wobble Bird Base
with included Tripod Stand
8
Note: some linkage components
have been removed from this
image for greater clarity.
16
7
10
6
16
12
14
13
9
1
Summary of Contents for 40924
Page 2: ......