100440 - 3000 LB. WINCH KIT
ASSEMBLY
9
Mounting the Remote Control
1. The remote control is usually installed on the left
handlebar.
2. Use a piece of electrical tape around the handlebar
to help prevent rotation of the mount on the
handlebar. Do NOT tighten over any hoses or
cables.
3. Once the remote control is mounted you can route
the wires back to the battery and winch.
4. Make sure the handlebars have full range of
motion and then secure the remote control’s cable.
Wiring the Winch
!
CAUTION
NEVER route electrical cables across any sharp
edges, through and/or near moving parts, or near
parts that may become hot.
!
CAUTION
Battery cables should not be drawn taut. Leave some
slack for cable movement.
1. Mount the winch to your vehicle.
2. FOR WINCH TO FULLY FUNCTION, CONNECT ALL
LEADS CORRECTLY.
3.
Connect the battery leads:
3a. Connect the red (+) lead to the positive (+)
terminal of the vehicle’s 12 volt battery.
3b. Connect the black (–) lead to the negative (–)
terminal of the vehicle’s 12 volt battery.
See wiring diagram.
4.
Connect the winch leads:
4a. Connect red (+) lead of the winch connection
cables to the positive (+) terminal of the
winch motor.
4b. Connect the black (–) lead of the winch
connection cables to the negative (–) terminal
of the winch motor. See wiring diagram.
WINCH WITH REMOTE
CONTROL ONLY
5. Check for proper drum rotation. Pull and turn the
clutch knob to the “out” position (Free spooling).
Pull out some rope from the drum, and then turn
the clutch knob to the “In” position to engage the
gears. Press the rope out button on the handlebar
switch. If the drum is turning and releasing more
rope then your connections are accurate. If the
drum is turning and collecting more rope then
reverse the leads on the motor. Repeat and check
rotation.
