![background image](http://html.mh-extra.com/html/champion/100326-1/100326-1_operators-manual_2588760018.webp)
100326-1 - 25 TON FULL BEAM LOg SPLiTTER
ASSEMBLY
18
7) install the Log Catchers
Large Log Catcher (Engine Side)
1. With the log catcher angled upward, align the four holes
on the log catcher with the 4 threaded holes on the splitter
beam.
2. Place M10 flat washers (22) and M10 lock washers (21) onto
the four M10 x 20 bolts (20) and thread them through the
holes on the log catcher and into the holes on the splitter
beam and tighten securely.
20
22
21
Small Log Catcher (hydraulic hose Side)
3. With the log catcher angled downward and under the lip of
the splitter beam, align the two holes on the log catcher with
the two holes on the beam lip.
4. Place the two M10 x 30 bolts (A) through the holes on the
beam and through the holes on the log catcher. Place a M10
flat washer (B) and a M10 lock washer (C) onto the bolt (A)
from the bottom side and thread the M10 nuts (D) onto the
bolts and tighten securely.
CORRECT aSSEmBLY
ORIENTaTION
A
C
B
D
INCORRECT aSSEmBLY
ORIENTaTION
A
C
B
D
Add Engine Oil
CAUTiON
DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the engine as a result of failure to follow these
instructions will void your warranty.
NOTiCE
The recommended oil type is
10W-30 automotive oil
.
-20
0
20
40
60
Ambient temperature
Recommended Engine Oil Type
80
100
120
-28.9
°F
°C
-17.8 -6.7 4.4
15.6 26.7 37.8
48.9
10W-30
5W-30 Synthetic
10W-40
5W-30
1. Place the log splitter on a flat, level surface.
2. Remove oil fill cap/dipstick to add oil.
3. Using a funnel, add up to 16.9 fl. oz (500 ml) (not include) of
oil and replace oil fill cap/dipstick. DO NOT OVERFILL.
4. Check engine oil level daily and add as needed.
MAX
OIL DIP STICK