18
ENGLISH
RT10010
1. Stop the engine.
2. Remove the hopper (4) and discharge chute
(15) (fig. 26-27). Ensure both are free of any
obstructions.
3. To allow access to the blade shaft remove the two
nuts from the blade shaft cover (14) (fig. 28 ).
4. Rotate the blade shaft as required using a 17mm
spanner (not supplied) (fig. 29).
5. Carefully clean out the cutting and discharge
area. Ensure that all debris is removed to prevent
the blades from clogging. The discharge area should
be free of all organic matter (fig. 30).
6. Once the blades are completely clean refit blade
shaft cover (14),hopper (4) and discharge chute
(15).
– The engine should be cool enough to touch
before performing any maintenance.
– Inspect and maintain the wood chipper before
each use. If the wood chipper has been used
previously, it must be inspected and maintained
before each subsequent use.
– Always shut off the engine before
inspecting, cleaning, adjusting, or repairing the wood
chipper.
Fig.26
Fig.29
Fig.30
Fig.27
Fig.28
MaIntenance