9
ENGLISH
100274
OPERATION
If the wire cable becomes kinked or twisted
during operation stop use immediately .
CAUTION
Do not exceed rated load capacity, even while
testing a load .
WARNING
Inspection
Before use of the utility winch, always inspect
the winch, power connections, wire cable, load
connections, and winch area for any possible
damage or hazards . Never connect a load to or
operate a winch, if it or any of it’s parts appear to
be worn or damaged .
Connecting a load
During connection of a load and operation of
the winch, the user should keep hands and
fingers clear of pinch points, moving parts, the
wire cable and hook . Lose clothing and jewelry
should not be worn, and long hair should be tied
back while connecting a load and operation .
Gloves and safety goggles should be worn at all
times when connecting or winching a load . The
cable should never be allowed to slide through
the users hands . The user should only grab the
hook, using a hook strap (not included) when
loading/unloading an item . Never grab the wire
cable directly . Attach the load to the hook using
only rated equipment, such as slings, chains or
winching shackles . Connection to the hook must
be completely secure to prevent any accidental
disconnection . Make sure the connection device
is properly seated in the base of the hook and
that the safety clasp closes fully .
Always check the wire cable for any wear, fraying
or damage . Only wire cable in good condition
should be used . If the wire cable appears worn,
frayed or damaged, DO NOT connect any load to or
use, replace immediately .
Incorrect
Incorrect
Correct
Inspect the wire cable to make sure it is spooled
correctly . The wire cable should not be overlapping
on itself, have space between the rolls or slack in
it . If the wire cable is spooled incorrectly do not
connect a load to it or use it until the wire cable
has been re-spooled correctly .
Once a load has been properly connected,
drape a blanket or jacket over the wire cable
approximately 5 to 6 ft . (1 .5 to 1 .8 m) from
the hook . In the event of a broken cable it will
dampen the snap back . Make sure and do a test .
Winch the load 1 to 2 in . (2 .5 to 5 .1 cm) and
pause a moment to inspect all connections and
that the equipment can handle the load .
It is highly recommended that random
inspections also be done during operation .
NOTE
