8
100274
ENGLISH
Battery clamps may become hot during use .
Please exercise caution when touching or
removing them after they have been hooked
up to a battery .
CAUTION
Never leave the battery clamps hooked up to a
live battery . Always disconnect battery clamps
from battery when not in use .
WARNING
The female plug end of the battery cables will
only fit into the socket one way . (A)
NOTE
The male plug end of the remote cable will only
fit into the socket one way . (B)
NOTE
The remote will only draw in the wire cable onto
the spool . It will not feed out the wire cable .
NOTE
ASSEMbly
Temporarily Wiring the Winch
Your utility winch can be temporarily wired to a
12V battery .
1 . Find a safe location for the winch so the
battery cables will not be pinched, cut or
damaged .
2 . Remove the protective plastic covering on the
winch that covers the socket that houses the
male ends .
3 . Plug in the female ends of the battery cable
into the socket . (A)
4 . Route the battery cables from the winch
location to the battery location, securing
them along an anchor or frame .
5 . Use the Red positive (+) battery clamp and
attach the clamp to the Red positive (+)
terminal of the battery .
6 . Use the Black negative (-) battery clamp from
the wire and attach the clamp to a bare metal
part of the frame of the vehicle or another
bare metal part not on the battery or winch,
to create a secure and safe electrical ground .
Remote Control
Your utility winch comes with a handheld wired
remote control . The remote control is easy to
connect . Once the winch has been connected to a
battery and properly grounded, remove the plastic
protective piece on the winch . Next take the male
ends of the remote control cord and plug them
into the female end connectors in the winch . (B)
Test the remote by using the clutch to draw out
some wire cable and then winching the wire cable
in about 1 to 2 in . (2 .5 to 5 .1 cm) .
b
A
