CHA TD 2.0
Page 8
Terminating Resistor Unit Assembly
Before first use of the CHA TD 2.0, perform the following procedure to assemble the Terminating
Resistor Units, Antenna Wires, and Counterpoise Wires to enable rapid field deployment.
Refer to plate (6) for assembly details.
1.
Carefully cut the zip tie holding a
Counterpoise Wire (G) roll together.
2.
Install a Carabiner (J) in the Loop (K) which
is on the end of the Counterpoise Wire that
has also has a Terminal Lug (I).
3.
Attach the Carabiner to the Strain Relief
Point (P) of a Terminating Resistor Unit (M)
that is on the opposite end from the
Suspension Point (O).
4.
Connect the Terminal Lug to the Resistor
Connector (N) on the side of the
Terminating Resistor Unit, as shown in plate
(6). Tighten the wing nut finger tight.
Plate 6. Terminating Resistor Connection Details.
5.
Carefully cut the zip tie holding an Antenna
Wire (H) roll together.
6.
Install a Carabiner on an Insulating Ring (L)
at one end of the Antenna Wire.
7.
Attach the Carabiner to the Strain Relief
Point of the Terminating Resistor Unit that
is on the same end of the Line Winder as
the Suspension Point.
8.
Connect the Terminal Lug to the Resistor
Connector on the side of the Terminating
Resistor Unit, as shown in plate (6). Tighten
the wing nut finger tight.
9.
Wind the Counterpoises Wires onto the
Line Winders between the Counterpoise
Wire Winding Notches (S).
10.
Wind the Antenna Wires onto the Line
Winders using the Antenna Wire Winding
Notches (R) and secure with Shock Cord (Q).
The completed assembly should look like that
pictured in plate (7).
11.
Repeat steps (1)
–
(10) for the other set.
12.
Tie one end of the Long Mini-Paracord (W)
to the Throw Bag (U) using a Fisherman’s
Knot or similar knot.
13.
Wind Long Mini-Paracord onto Mini-Line
Winder (Z)
14.
Place all CHA TD 2.0 components into the
Duffel Bag for storage and to be ready for
rapid deployment.
Plate 7. Wires Wound on Line Winder.
