CHA TD 2.0
Page 14
24.
Connect a UHF Plug (Y) at one end of the
Coaxial Cable (X) to the UHF Socket (F) on
the bottom of the Matching Transformer
Unit.
25.
Rewind Long Mini-Paracord onto Mini-Line
Winder (Z).
26.
Return any unused components to the
Duffel Bag and perform an operational test.
Plate 9. Sloping Wire Antenna Connection Details.
Recovery Procedure
To recover the CHA TD 2.0, perform the following steps:
1.
Disconnect the Coaxial Cable from the Radio Set.
2.
Lower the antenna to the ground.
3.
Disconnect the Coaxial Cable from the Matching Transformer Unit.
4.
Carefully roll (do not twist) the Coaxial Cable.
5.
Untie the Mini-Paracord from the Matching Transformer Unit or Terminating Resistor Unit, if used.
6.
Neatly roll up the Mini-Paracord onto the Mini-Paracord Line Winder.
7.
If the Sloping Wire antenna configuration was deployed, reattach the Counterpoise Wire to the
Terminating Resistor Unit to enable rapid future deployment of the antenna.
8.
Wind the Antenna Wires and Counterpoise Wires onto their Terminating Resistor Unit Line Winders
and secure with attached Shock Cord.
9.
Pull the Tent Stakes from the ground.
10.
Remove dirt from antenna components and inspect them for signs of wear.
