11
GROUND WIRE
GROUND
SCREW
WHITE
WIRES
BLACK
WIRES
THREE PRONG GROUNDING PLUG
To reduce the risk of shock, this operator has a grounding
type plug, that has a third (grounding) pin. This plug will
only fit into a grounding type outlet. If this plug does not
fit into the outlet, contact a qualified electrician to install
the proper outlet. Do not change the plug in any way.
Refer to figure 5.
PERMANENT WIRING
If permanent wiring is required by your local code,
refer to the following procedure:
To make a permanent connection through the 7/8” diame-
ter hole in the bottom of the operator:
1. Open hinged front panel by loosening 2 cover screws.
Refer to figure 7.
1a. Remove internal shield.
2.
Remove the 3-prong cord.
3. Connect the black (line) wire to the screw on the brass
terminal; the white (neutral) wire to the screw on the
silver terminal; and the ground wire to the green
ground screw.
The opener must be grounded.
Refer
to figure 6.
3a. Re-install internal shield.
4. Re-install the cover.
POWER WIRING
LOOSEN 2 COVER SCREWS FOR ACCESS
TO POWER/ CONTROL WIRING AND LIMIT/
FORCE ADJUSTMENTS.
FIGURE 5
FIGURE 6
FIGURE 7
WARNING
CAUTION
WARNING
WARNING
To prevent possible SERIOUS INJURY or DEATH
from electrocution or fire:
Be sure power is not connected to the opener, and
disconnect power to circuit BEFORE removing
cover to establish permanent wiring connection.
Garage door installation and wiring MUST be in
compliance with all local electrical and building
codes.
NEVER use an extension cord, 2-wire adapter, or
change plug in any way to make it fit outlet. Be
sure the opener is grounded.
