Safety Re
v
ersing Sensor
Horizontal and
v
ertical reinforcement
is needed for light
w
eight garage doors
(fi
b
erglass, steel, al
u
min
u
m, door
w
ith
glass panels, etc.). See page 23 for details.
S
u
pport
b
racket &
fastening hard
w
are
is re
qu
ired.
See page 19.
— — — — — — — —
Header
W
all
Safety Re
v
ersing
Sensor
Gap
b
et
w
een floor
and
b
ottom of door
m
u
st not exceed 1/4" (6 mm).
FI
N
ISHED CEILI
N
G
Torsion
Spring
Access Door
Motor
u
nit
W
all-
mo
u
nted
Door
Control
Rail
Extension
Spring
OR
Vertical
Centerline
of Garage
Door
4
SECTIONAL DOOR INSTALLATION
Planning
Identify the type and height of your garage door. Survey
your garage area to see if any of the conditions below
apply to your installation. Additional materials may be
required. You may find it helpful to refer back to this page
and the accompanying illustrations as you proceed with
the installation of your opener.
Depending on your requirements, there are several
installation steps which may call for materials or
hardware not included in the carton.
• Installation Step 1 – Look at the wall or ceiling above
the garage door. The header bracket must be securely
fastened to structural supports.
• Installation Step 4 – Depending upon garage
construction, extension brackets or wood blocks may
be needed to install sensors.
• Installation Step 4 – Alternate floor mounting of the
safety reversing sensor will require hardware not
provided.
• Installation Step 6 – Do you have a finished ceiling in
your garage? If so, a support bracket and additional
fastening hardware may be required.
• Do you have an access door in addition to the garage
door? If not, Model 7702CB Emergency Key Release
is required. See Accessories page.
• Look at the garage door where it meets the floor. Any
gap between the floor and the bottom of the door must
not exceed 1/4" (6 mm). Otherwise, the safety reversal
system may not work properly. See Adjustment Step 3.
Floor or door should be repaired.
SECTIONAL DOOR INSTALLATIONS
• Do you have a steel, aluminum, fiberglass or glass
panel door? If so, horizontal and vertical reinforcement
is required (Installation Step 12).
• The opener should be installed above the center of the
door. If there is a torsion spring or center bearing plate
in the way of the header bracket, it may be installed
within 4 feet (1.2 m) to the left or right of the door
center. See Installation Steps 1 and 12.
Header
Bracket
Rail Bracket
Trolley
Straight
Door
Arm
Emergency
Release
Rope & Handle
Door
Bracket
Garage
Door
Curved
Door
Arm
Garage
Door
Spring
Header
Wall
Rail Assembly
CLOSED POSITION
