2
3
4
NOTI
CE
2
1
17
2
1
24V/21WMax
18
Attach Emergency Release Rope & Handle
Thread one end of rope (1) through hole in top of red handle
so "NOTICE" reads right side up as shown (3). Secure with
an overhand knot (2). Knot should be at least 25mm (1")
from end of the rope to prevent slipping.
Thread other end of rope through hole in release arm of the
outer trolley (4). Adjust rope length so that handle is 1.8m
(6 feet) above the floor. Secure with an overhand knot.
NOTE:
If it is necessary to cut rope, heat seal cut end with
a match or lighter to prevent fraying.
Connect Electric Power
TO AVOID INSTALLATION DIFFICULTIES, DO NOT RUN THE GARAGE DOOR OPENER UNTIL
INSTRUCTED TO DO SO.
Ensure door opener is installed to a power outlet with trip switch or fuse.
Install Light
Gently pull lens (2) downward until the lens hinge is in the fully
open position. Do not remove the lens. Install a 24V/21W
maximum light bulb (1) in the socket as shown. The light will
turn on and remain lit for 2-1/2 minutes when power is
connected. After 2-1/2 minutes it will turn off. To close, gently
push diffuser up until engaged.
Replace burnt out bulbs with heavy duty light bulbs.
19
1
2
A. 0-100mm
B. 150-250mm
3
4
7
6
2
1
4
5
3
A
4
B
7
6
A
B
1
4
C
1
2
3
3
1
2
4
10
1
2
Fasten Door Bracket
If you have a canopy garage door, a door arm conversion kit is required. Follow the installation instructions included with the
replacement door arm. Exercise care in removing and assembling arm conversion kit. Keep fingers away from the sliding
parts.
NOTE:
Horizontal and vertical reinforcement is needed for lightweight garage doors.
Sectional and One-Piece Door Installation Procedure:
Door bracket (1) has left and right side fastening holes. If your installation requires top and bottom fastening holes use
both the door bracket and door bracket plate (2) as shown.
1. Center door bracket (with or without door bracket plate, as required) at the top inside face of door as shown. Mark
holes.
A.Standard Sectional or One-piece doors:
locate bracket at inside face of the door.
B. Sectional doors with two horizontal roller channels:
150 - 250mm below the top of the door.
2.
A. Wooden doors
Drill 8mm holes (5/16") and fasten the door bracket with nut, lock washer, and carriage bolt
(3).
B. Sheet metal doors
Fasten with wood screws
(4)
.
C. One-piece door optional
Fasten with wood screws
(4)
.
