12
Installers must ensure that the doors are installed in a compliant manner as per AS/NZS 60335-2-95.
TRAVEL SPEED: Automatically selected:
There are two travel speeds available for this opener.
The speed is a function of door travel distance and is automatically set during the door travel limit setting process.
* Travel distance longer then 1.6 metres = REGULAR speed
* Travel distance shorter than 1.6 metres = SLOW speed (will suit tilt doors best.)
TRAVEL SPEED: Manually selected:
The speed can be set manually if required, once the travel limits have been set, using the following method.
To activate the alternate speed:
PRESS and HOLD both the
UP
and
DOWN
arrows for 3 seconds.The courtesy lamp will flash once to confirm SLOW
speed and twice to confirm REGULAR speed.
To deactivate the selected speed:
Repeat the process above (toggle between the two settings).
PROGRAM THE TRAVEL SPEED (OPTIONAL)
20
TEST THE SAFETY REVERSE SYSTEM
Procedure:
With door opened place a 40 mm obstacle (1) laid flat on the floor under the garage door.
Operate the door in the down direction. The door must reverse off the obstacle. If the door stops on the
obstacle, remove obstacle and repeat Program the Limits and Force Steps, then repeat safety reverse
test.
When the door reverses off the 40 mm obstacle, remove the obstacle and run the opener through a
complete travel cycle. Door must not reverse in closed position. If it does, repeat Program the Limits
and Force then repeat safety reverse test.
1
40mm
1
40 mm high
The safety reverse system test is important. Garage door must reverse on
contact with a 40 mm obstacle laid flat on the floor. Failure to properly adjust
opener may result in serious personal injury from a closing garage door.
Repeat test once a month and adjust as needed.
19
