Chamberlain LiftMaster TAC1, Installation And Programming Manual

Page: 13 / 20

13
PROGRAMMING
>> FROM THE TAC1 KEYPAD
GENERAL INSTRUCTION
CHANGE THE MASTER CODE
1. Enter the Master Code:
? ? ? ?
2. Enter the Program Code: 0 9 The unit will beep.
3. Enter:
# # #
4. Enter the new Master Code:
? ? ? ?
The unit
will beep.
Write down the Master Code and store in a secure
location.
MICROPHONE SENSITIVITY
Allows the resident to hear the visitor at the unit,
1 = Low, 2 = Medium and 3 = High.
Default level is 2.
1. Enter the Master Code:
? ? ? ?
2. Enter the Program Code: 0 7
3. Enter the Volume Level:
1
or
2
or
3
SPEAKER VOLUME
Allows the visitor to hear the resident at the unit,
1 = Low, 2 = Medium and 3 = High.
Default level is 2.
1. Enter the Master Code:
? ? ? ?
2. Enter the Program Code:
0 6
3. Enter the Volume Level:
1
or
2
or
3
ADJUST RELAY OUTPUT TIME (RELAY 1)
The amount of time (in seconds) the relay remains active.
Default level is 0.5 seconds.
1. Enter the Master Code:
? ? ? ?
2. Enter the Program Code:
0 2 4
3. Enter the Output Time (in seconds):
? ? ? ?
Example:
0000 = 0.5 Seconds (Minimum)
0010 = 10 Seconds
8000 = 8000 Seconds (Maximum)
ADJUST RELAY OUTPUT TIME (RELAY 2)
The amount of time (in seconds) the relay remains active.
Default level is 0.5 seconds.
1. Enter the Master Code:
? ? ? ?
2. Enter the Program Code: 0 2 5
3. Enter the Output Time (in seconds):
? ? ? ?
Example:
0000 = 0.5 Seconds (Minimum)
0010 = 10 Seconds
8000 = 8000 Seconds (Maximum)
ENABLE TELCO MODE
Telco Mode is using the main telephone line for the unit’s
communications to the house or complex.
1. Enter the Master Code:
? ? ? ?
2. Enter the Program Code:
0 4
ENABLE INTERCOM (NO TELCO) MODE
1. Enter the Master Code:
? ? ? ?
2. Enter the Program Code: 0 3
ENABLE INDEPENDENT RELAY OUTPUT CONTROL
1. Enter the Master Code:
? ? ? ?
2. Enter the Program Code:
0 2 3
ENABLE PARALLEL RELAY OUTPUT (DEFAULT)
1. Enter the Master Code:
? ? ? ?
2. Enter the Program Code: 0 2 1
NOTE: Use the STAR Key “*” to cancel any input.
NOTE: Keypad commands are to be entered in a single string to result in success (indicated by double high success tone). Stop and go
keystrokes will result in negative tones (low single and triple fail tones).
8 9 7
0
2 3 1
5 6 4
PROGRAMMING INSTRUCTION SYNTAX KEYSTROKES
General Programming Master Code + Command 1234 + 1 (12,123)
Code Programming Master Code + C Code 1234 +1(12) + 1234
Relay Programming Master Code + C Setting 1234 + 123 + 1234
Level Adjustment Master Code + C Setting 1234 + 12 + 1-3