FIGURE 1
RECEIVER UNIT
1. Attach receiver unit near motor operator by pre-drilling
guide holes and using #8 or #10 fasteners (Refer to page 3
figures 4 & 5).
2. Wire receiver to operator (Refer to page 2 figure 1).
3. Attach the Receiver unit with nuts and lockwashers, making
sure the reception window and LED’s are facing downward
(Refer to page 3 figure 5).
RECEIVER WIRE CONNECTIONS
TRANSMITTER UNIT
1. Install Transmitter Unit housing to the door edge by pre-drilling
guide holes and using #8 or #10 fasteners (Refer to page 3
figure 6).
2. Open front cover by removing 2 screws (Refer to page 3
figure 3).
a.
(ELECTRIC ONLY)
Wire transmitter to safety edge
(Refer to page 5).
3. Insert the 3V lithium battery in the battery clips noting
correct polarity.
4. Replace front cover.
5.
(PNEUMATIC ONLY)
Connect hose (Refer to page 3 figure 3).
6. Attach transmitter unit with nuts and lockwashers (Refer to
page 3 figure 6). Route cable or hose through channel on front
of cover (Refer to page 2, figure 2).
NOTE:
Do not kink or crush pneumatic tubing.
The supervised edge system consists of two distinct components,
the transmitter and the receiver. The receiver, which is connected
to the operator, behaves like a normally open safety edge. The
receiver requires a power and ground connection (DC) or an
AC connection. The transmitter is connected to the safety edge
and uses an internal 3V lithium battery for power. Battery life
is estimated at one year, however, conditions may vary. For
convenience, a low battery warning tone wil sound to indicate that
replacement is required (See diagnostics). The system requires
several considerations when deciding upon where to locate the
units on the door.
NOTE:
Refer to door system illustration on page 3 for basic door
setup. Location and configuration may differ from illustration.
1. Both units must be located on the same side of the door. There
must be a clear line of sight between the units throughout
door/grill range of travel (Refer to page 3, figure 4).
2. The transmitter must always remain below the receiver
throughout the door’s range of travel.
3. The receiver placement must be within 2' of transmitter
centerline (Refer to page 3, figure 5).
CABLE & HOSE SUPPORT
S E L E C T I N G M O U N T I N G L O C A T I O N
R E C E I V E R A N D T R A N S M I T T E R I N S T A L L A T I O N
Door Operator
+24V DC or 24V AC- Red
DC Ground or 24V AC- Black
Safety
Edge Connection- Green
Safety Edge Connection- White
FIGURE 2
Channels
To avoid SERIOUS personal INJURY or DEATH from
electrocution:
• Disconnect ALL electric and battery power BEFORE
performing ANY service or maintenance.
ATTENTION
AVERTISSEMENT
AVERTISSEMENT
AVERTISSEMENT
WARNING
CAUTION
WARNING
WARNING
WARNING
PRECAUCIÓN
ADVERTENCIA
ADVERTENCIA
ADVERTENCIA
2
