25
Header Wall
Vertical
Centerline of
Garage Door
Finished Ceiling
Optional
Placement
of Door
Bracket
Header
Bracket
Door
Bracket
2x4 Support
For a door with no exposed framing,
or for the optional installation, use
lag screws 5/16"x1-1/2" (Not Provided)
to fasten door bracket.
METAL DOOR
Top of Door
(Inside
Garage)
Door
Bracket
Optional
Placement
Top Edge
of Door
Self-Threading
Screw
1/4"-14x5/8"
Door
Bracket
Top of Door
(Inside
Garage)
Carriage Bolt
5/16"x2"
(Not Provided)
Optional
Placement
Lock
Washer
5/16"
Nut
5/16"-18
Top Edge
of Door
WOOD DOOR
HORIZONTAL AND VERTICAL
REINFORCEMENT IS NEEDED
FOR LIGHTWEIGHT GARAGE
DOORS (FIBERGLASS,
ALUMINUM, STEEL, DOORS
WITH GLASS PANEL, ETC.).
(NOT PROVIDED)
ONE-PIECE DOORS
Please read and comply with the warnings and
reinforcement instructions on the pre
v
ious page.
They apply to one-piece doors also.
• Center the door
b
racket on the top of the door, in
line with the header
b
racket as shown. Mark either
the left and right, or the top and
b
ottom holes.
•
Metal Doors:
Drill 3/16" pilot holes and fasten the
b
racket with the 1/4"-14x5/8" self-threading screws
pro
v
ided.
•
Wood Doors:
Drill 5/16" holes and use 5/16"x2"
carriage
b
olts, lock washers and nuts (not
pro
v
ided) or 5/16"x1-1/2" lag screws (not pro
v
ided)
depending on your installation needs.
NOTE:
The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Self-Threading Scre
w
1/4"-14x5/
8
"
HARDWARE SHOWN
ACTUAL SIZE