Operation
Features
Your garage door opener is equipped with features to provide you with greater control over your garage
door operation.
REMOTE CONTROLS AND DOOR CONTROLS
Your garage door opener has already been programmed at the factory to operate with your remote
control,which changes with each use, randomly accessing over 100 billion new codes.
NOTE:
Older Chamberlain remote controls, door controls, and third party products are not compatible.
Accessories
MEMORY CAPACITY
Remote Controls
Up to 8
Door Controls
Up to 2 door controls
Keyless Entries
Up to 1
THE PROTECTOR SYSTEM
®
(SAFETY REVERSING SENSORS)
When properly connected and aligned, the safety reversing sensors will detect an obstruction in the path
of the infrared beam. If an obstruction breaks the infrared beam while the door is closing, the door will
stop and reverse to full open position, and the opener lights will flash 10 times. If the door is fully open,
and the safety reversing sensors are not installed, or are misaligned, the door will not close from a
remote control. However, you can close the door if you hold the button on the door control or keyless
entry until the door is fully closed. The safety reversing sensors do not effect the opening cycle.
ENERGY CONSERVATION
For energy efficiency the garage door opener will enter sleep mode when the door is fully closed. The
sleep mode shuts the garage door opener down until activated. The sleep mode is sequenced with the
garage door opener light bulb; as the light bulb turns off the sensor LEDs will turn off and whenever the
garage door opener lights turn on the sensor LEDs will light. The garage door opener will not go into the
sleep mode until the garage door opener has completed 5 cycles upon power up.
LIGHTS
The garage door opener light bulbs will turn on when the opener is initially plugged in; power is restored
after interruption, or when the garage door opener is activated. The lights will turn off automatically after
4-1/2 minutes. Bulb size is A19. Bulb power is 100 watts maximum.
NOTE:
Do not use halogen, short
neck, or specialty light bulbs as these may overheat the end panel or light socket. Do not use LED bulbs
as they may reduce the range or performance of your remote controls.
Light Feature
The garage door opener is equipped with an added feature; the lights will turn on when someone enters
through the open garage door and the safety reversing sensor infrared beam is broken. For added
control over the light bulbs on your garage door opener, see page 33.