en-1
PLEASE START BY READING THESE IMPORTANT SAFETY RULES
This safety alert symbol means "Caution" - failure to comply with such an instruction involves risk of personal
injury or damage to property. Please read these warnings carefully.
This gate drive mechanism is designed and tested to offer appropriately safe service provided it is installed and
operated in strict accordance with the following safety rules.
Incorrect installation and/or failure to comply with the following instructions may result in serious personal
injury or property damage.
Installation and wiring must be in compliance
with your local building and electrical
installation codes. Power cables must only be
connected to a properly earthed supply.
Disconnect electric power to the system before
making repairs or removing covers.
A disconnecting device must be provided in the
permanently-wired installation to guarantee all-
pole disconnection by means of a switch (at least
3mm contact gap) or by a separate fuse.
When using tools and small parts to install or
carry out repair work on a gate exercise caution
and do not wear rings, watches or loose
clothing.
Make sure that people who install, maintain or
operate the gate drive and/or the control board
are qualified and follow these instructions.
Keep these instructions in a safe place so that
you can refer to them quickly when you need to.
Please remove any locks fitted to the gate in order
to prevent damage to the gate.
Frequently examine the installation for imbalance
and signs of wear or damage to cables, hardware
and mountings. Do not use if repair or
adjustment is necessary. Gates which stick or
jam must be repaired immediately. Employ a
qualified technician to repair the gate, never
attempt to repair it yourself.
Keep additional accessories away from children.
Do not allow children to play with pushbuttons
or remote controls. A gate can cause serious
injuries as it closes.
After the installation a final test of the full
function of the system and the full function of
the safety devices must be done.
The full protection against potential squeeze or
entrapment must work direct when the drive arms
are installed.
This drive cannot be used with a gate
incorporating a wicket door unless the drive
cannot be operated with the wicket door open.
IMPORTANT FITTING AND OPERATING INSTRUCTIONS
WARNING / ATTENTION
Lightweight gates must be substantially
reinforced to avoid gate damage. The best
solution is to check with your gate manufacturer
for an opener installation reinforcement kit.
Gate must not extend over public byway during
operation.
Activate opener only when the gate is in full
view, free of obstructions.
Do not allow children to play near the gate.
This appliance is not intended for use by
persons (including children) with reduced
physical sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
SAVE THESE INSTRUCTIONS
Entrapment protection devices MUST be
installed to protect anyone who may come
near a moving gate. Locate entrapment
protection devices to protect in BOTH the
open and close gate cycles. Locate
entrapment protection devices to protect
between moving gate and RIGID objects,
such as posts.
Controls must be far enough from the gate so
that the user is prevented from coming in
contact with the gate while operating the
controls.
Humidity and water destroy the control board.
Make sure under all circumstances that water,
humidity or dammed-up water cannot penetrate
the control board covering.
Automatic drive – Keep away from the area of the
gate since it may operate unexpectedly.
