30
Adjustments
STEP 2 Test the Safety Reversal System
Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY
INJURED or KILLED by a closing garage door.
l
Safety reversal system MUST be tested every month.
l
After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on
contact with 1-1/2" (3.8 cm) high object (or 2x4 laid flat) on the floor.
1.
With the door fully open, place a 1-1/2 inch (3.8 cm) board (or a 2x4 laid flat) on the floor, centered under
the garage door.
2.
Press the remote control push button to close the door. The door MUST reverse when it makes contact
with the board.
If the door stops but does not reverse:
1.
Review the installation instructions provided to insure all steps were followed;
2.
Repeat Program the Travel (see Adjustment Step 1);
3.
Repeat the Safety Reversal test.
If the test continues to fail, call a trained door systems technician.
1
2
STEP 3 Test the Protector System
®
Without a properly installed safety reversing sensor, persons (particularly small children) could be SERIOUSLY
INJURED or KILLED by a closing garage door.
1.
Open the door. Place the garage door opener carton in the path of the door.
2.
Press the remote control push button to close the door. The door will not move more than 1" (2.5 cm), and
the garage door opener lights will flash 10 times.
The garage door opener will not close from a remote control if the LED in either safety reversing sensor is off (alerting
you to the fact that the sensor is misaligned or obstructed). If the garage door opener closes the door when the safety
reversing sensor is obstructed (and the sensors are no more than 6" [15 cm] above the floor), call for a trained door
systems technician.
1
2
