1
Carton Inventory
Overview
The Perimeter Alert Sensor is a Passive Infra-Red (PIR) Motion Sensor that detects movement of people and vehicles, while allowing
small animals to pass through undetected. Each sensor has its own unique ID, for a secure radio link. The base station (not provided)
can learn the signals of up to 8 sensors. The base station gives a single beep for the fi rst sensor that is programmed, a double beep for
the second, and so on. Additionally, multiple base stations can work with the same sensor to sound in different places.
Assembly & Programming
Attach PIR Motion Sensor box
to mounting plate with large
silver screw. Tighten screw
until PIR Motion Sensor stays
in place when repositioned.
Model 836LM
PERIMETER ALERT SENSOR
Passive Infra-Red (PIR)
Motion Sensor
Swivel Bushing
Mounting Plate
Sun/Rain Shield
1
Install 4 AA Alkaline
batteries. (Lithium batteries
recommended for colder
environments.)
LED light will fl ash.
2
Antenna
ON
OFF
1
2
SWITCH SETTINGS
Switch #1
Switch #2
Learn
Button
OFF Low
Sensitivity
ON
High Sensitivity (Default)
OFF
15 Feet Detection Range
ON
30 Feet Detection Range
(Default)
NOTE:
To avoid unwanted detection of small animals move
Switch #2 to OFF.
PIR Motion Sensor
SWITCH #1:
SWITCH #2:
A
Ensure Base Station and PIR
Motion Sensor are in close
proximity to each other.
Press and release Learn
Button on Base Station.
Buzzer will sound.
B
Within 60 seconds, press the
Learn Button on the inside of
the PIR Motion Sensor. LED
light will illuminate and Base
Station will buzz.
Learn Button
3
Learn Button
Test PIR Motion Sensor by
waving hand in front of sensor.
LED light should fl ash and
the Base Station will buzz X
number of times indicating
which sensor has been
activated.
Insert battery pack facing away
from circuit board and fasten
cover with the smallest screws
(provided).
NOTE:
Ensure the batteries do
not touch the circuit board and
the antenna and battery wires
are not pinched.
4
5
