31
To Add or Reprogram a Remote Control (Model 895MAX)
USING THE “LEARN” BUTTON
USING THE SMART CONTROL PANEL
®
PROGRAMMING
Your garage door opener has already been programmed at the factory to operate with your hand-held
remote control. The door will open and close when you press the button shown.
Below are instructions for programming your garage door opener to operate with additional
895MAX remote controls. To program additional remote controls, refer to the instructions
provided with the remote control.
Factory Programmed Button
1.
To enter programming mode, press the Program
button until the LEDs on the front of the remote control
turn on.
2.
Press and release the Learn button on the garage door
opener. The Learn LED will light. Within 30 seconds...
3.
Press and release the remote control button you want to use...
Check to see if the garage door opener light bulb
blinks. If not, wait for the remote control LED to light
solid then
slowly
press and release the remote control
button again.
Repeat
until the light bulb blinks.
DO
NOT
press the button after the light bulb blinks.
4.
To exit programming mode, press any remote control button except the button that was just programmed.
2.
Press and release the Prog <Learn> button on the Smart
Control Panel
®
twice
. Within 30 seconds...
Safety Pin or
Paper Clip
OR
LEDs
Learn LED
Prog <Learn> Button
NOTICE:
If this Security
✚
®
garage door opener is operated with a non-rolling code transmitter, the technical measure
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, fi rst erase all codes:
Press and hold the “learn” button on motor unit until the learn indicator light goes out
(approximately 6 seconds). All previous codes are now erased. Reprogram each remote or
keyless entry you wish to use.
