Chamberlain 3595LM 3/4 HP, Owner'S Manual

Page: 16 / 36

16
FLOOR MOUNT (RIGHT SIDE)
WALL MOUNT (RIGHT SIDE)
DOOR TRACK MOUNT (RIGHT SIDE)
I ndicator
light
Lens
Lip
Sensor
Bracket
Door
Track
Sensor
Bracket
E x tension
Bracket
Lens
I ndicator
light
Lag Screw
1/4
x 1-1/2"
I
nside
Garage
Wal
l
I ndicator
light
Sensor
Bracket
Lens
E x tension
Bracket
I
nside
Garage
Wal
l
Lock Nut
1/4"-20
Lock Nut
1/4"-20
He x Bolt
1/4"-20 x 5/8"
He x Bolt
1/4"-20 x 5/8"
Lag Screw
1/4
x 1-1/2"
Figure 3
Figure 1
Figure 2
INSTALLING THE BRACKETS
Be sure power to the opener is disconnected. Install
and align the brackets so the sensors will face each other
across the garage door, with the beam no higher than
6" (15 cm) above the floor. They may be installed in one of
three ways, as follows:
Garage door track installation (preferred):
• Slip the curved arms over the rounded edge of each
door track, with the curved arms facing the door. Snap
into place against the side of the track. It should lie
flush, with the lip hugging the back edge of the track, as
shown in Figure 1.
If your door track will not support the bracket securely, wall
installation is recommended.
Wall installation:
• Place the bracket against the wall with curved arms
facing the door. Be sure there is enough clearance for
the sensor beam to be unobstructed.
• If additional depth is needed, an extension bracket or
wood blocks can be used.
• Use bracket mounting holes as a template to locate and
drill (2) 3/16" diameter pilot holes on the wall at each
side of the door, no higher than 6" (15 cm) above the
floor.
• Attach brackets to wall with lag screws.
• If using extension brackets or wood blocks, adjust right
and left assemblies to the same distance out from the
mounting surface. Make sure all door hardware
obstructions are cleared.
Floor installation:
• Use wood blocks or extension brackets to elevate
sensor brackets so the lenses will be no higher than
6" (15 cm) above the floor.
• Carefully measure and place right and left assemblies at
the same distance out from the wall. Be sure all door
hardware obstructions are cleared.
• Fasten to the floor with concrete anchors as shown.
Lag Screw
1/4x1-1/2" (4) Lock Nut
1/4"-20 (2) Hex Bolt
1/4"-20x5/8" (2)
Wing Nut
1/4"-20 Staples
Carriage Bolt
1/4"-20x1/2"
HARDWARE SHOWN ACTUAL SIZE