QAD#IM6010 RevD 11.01.19
HQ 006 INTRODUCTION
This installation and operating manual explains how to install, operate and maintain HQ-006 electric actuators.
Safety notices in this manual detail precautions the user must take to reduce the risk of personal injury and damage to the
equipment. User must read these instructions before installation, operating, or maintenance.
DANGER:
Refers to personal safety. Alerts the user to potential danger or harm. The hazard or unsafe practice will result
in severe injury or death.
WARNING:
Refers to personal safety. Alerts the user to potential danger. Failure to follow warning notices could result in
personal injury or death.
CAUTION:
Directs the user’s attention to general precautions that, if not followed could result in personal injury and/or equipment
damage.
Note: Highlights information critical to the user’s understanding of the actuators’ installation and operation.
PRODUCT IDENTIFICATION
The actuator name plate is located on the top cover of the actuator.
The name plate contains the following:
HQ logo (trade mark)
Electrical power supply
Model
Type
Rated current
Operating time (seconds)
Serial No.
Option
Initial Inspection
Upon receipt of the actuator, inspect the condition of the product and ensure the name plate matches the order sheet or your
requirements, also check for any damage that may have occurred during shipment. If the wrong product has been shipped
immediately or is damaged report to the coordinator.
Storage
Actuators must be stored in a clean, cool and dry area. The unit shall be stored with the cover fastened and the conduit openings
sealed. Storage must be off the floor, covered with a seal dust protector.
When actuators are stored outdoors, they must be stored off the ground, high enough to prevent being immersed in water or
buried in snow.
ELECTRIC ACTUATOR
QUARTERTURN ELECTRIC ACTUATORS
POWER:
TORQUE:
OPERATION TIME:
SEC
TYPE:
RATED CURRENT:
A
OPTION:
SERIAL NUMBER:
Name Plate
4
