HELPLINE NO 08454 505299
10
ORIGINAL INSTRUCTIONS
Your tool uses hook-and-loop backed
sandpaper, which firmly grips the backing
pad when applied with moderate pressure.
To change, merely peel off the old sandpaper,
remove dust from the backing pad if
2. INSTALLING AND REMOVING
ACCESSORIES
3. INSTALLING SANDING SHEETS
1. To install accessories, align holes in
accessory with locating pins on accessory
holder in desired position. Assure that pin
in holder are engaged into holes in
accessory and securely tighten with with
hex bolt provided (Fig. A).
Your accessories can be engaged into
accessory holder 12 positions 30 degrees
apart.
For intermediate position an adapter is
provided that will allow you to attach the
accessory in any position. Use of adapter
will also allow you to use most competitor
accessories.
2. To remove accessory, loosen and remove
hex bolt and remove accessory from
holder (Fig. B).
Fig A
Fig B
ASSEMBLY
1. Battery Charging
Only use the battery chargers are matched to
the lithium ion battery of your power tool.
Slide the battery pack towards at the charger.
Charger indicating light's condition
：
1. Charger power on
：
green light is on, red
light is off
2. During charging( insert battery): red light
is on
，
green light is off
3. Fully charging
：
green light is on, red light
is off
To remove the battery pack, pull the battery
pack out of the charger
The battery is supplied partially charged.
Completely charge the battery before using
your power tool for the first time. The lithium
ion battery can be charged at any time
without reducing its service life. Interrupting
the charging procedure does not damage the
battery.
WARNING!
WARNING!
Do not continue to press the On/Off
switch after the machine has been
automatically switched off.
The
battery can be damaged.
Observe the notes for disposal.
