HELPLINE NO 08454 505299
12
ORIGINAL INSTRUCTIONS
SAWING
Use undamaged faultless saw
blades only.
Deformed, blunt saw blades or saw blades
that are otherwise damaged can break.
OPERATION
SLIDE "ON/OFF" SWITCH
The tool is switched "ON" by the slide switch
located on the topside of the motor housing
Switching on:
TO TURN THE TOOL "ON" slide the switch
button forward to the “I” .
Switching off:
TO TURN THE TOOL "OFF" slide the switch
button backward the “0” .
WARNING! Hold the tool with both hands
while starting the tool, since torque from the
motor can cause the tool to twist.
Selecting the oscillation speed
NOTE: The required oscillation speed
depends on the material and the working
conditions and can be determined by means
of a practical test.
Preselect the required oscillation speed using
the oscillation speed setting wheel 2 .
Auxiliary Handle
When working with the machine,
always mount the auxiliary handle.
Screw in the auxiliary handle (7) on the
machine head depending on the chosen
working method.
This tool has two holes to change the
auxiliary handle position.
SANDING
1. Sanding accessories are suitable for dry
sanding of wood, metal, smaller surfaces
corners and edges and hard to reach
areas.
2. Profiles and grooves may be finished
using the tip or edge of the selected
accessory, which should occasionally be
rotated during use to distribute the wear
on the accessory and backing pad surface.
3. Always be certain that smaller workpieces
are securely fastened to a bench or other
support.
Larger panels may be held in place by
hand on a bench or sawhorses.
4 With the workpiece firmly secured, turn
tool on as described above.
When sawing light building
materials, observe the statutory
provisions and the recommendations
of the material suppliers.
Plunge cuts may only be applied to
soft materials, such as wood, gypsum
plaster boards, etc.!
Before sawing with HCS saw blades in wood,
particle board, building materials, etc., check
these for foreign objects such as nails, screws,
or similar. If required, remove foreign objects
or use 50CrV or higher quality saw blades.
Work with low and uniform
application pressure, otherwise, the
application tool can become blocked
or cause resonance.
