HELPLINE NO 08454 505299
10
ORIGINAL INSTRUCTIONS
Your tool uses hook-and-loop backed
sandpaper, which firmly grips the backing
pad when applied with moderate pressure.
To change, merely peel off the old sandpaper,
remove dust from the backing pad if
1. INSTALLING AND REMOVING
ACCESSORIES
2. INSTALLING SANDING SHEETS
1. To install accessories, align holes in
accessory with locating pins on accessory
holder in desired position. Assure that pin
in holder are engaged into holes in
accessory and securely tighten with with
hex bolt provided (Fig. A).
Your accessories can be engaged into
accessory holder 12 positions 30 degrees
apart.
For intermediate position an adapter is
provided that will allow you to attach the
accessory in any position. Use of adapter
will also allow you to use most competitor
accessories.
2. To remove accessory, loosen and remove
hex bolt and remove accessory from
holder (Fig. B).
Fig A
ASSEMBLY
Fig B
necessary, and press the new sandpaper in
place.(Fig C)
After considerable use the backing pad
surface will become worn, and the backing
pad must be replaced when it no longer offers
a firm grip. If you are experiencing
premature wear of the backing pad facing,
decrease the amount of pressure you
are applying during operation of the tool.
Fig C
