ASSEMBLY
Notes: Please read the important safety
instructions before use.
Assemble Hand Grip
1. Locate hand grip (5) over top of motor
unit , push down and align grip section.
(Dia.2)
2. Pass bolt (4) through adjusting knob (4)
and motor unit, and locate threaded
section in hand grip. (Dia.2)
3. Tighten using locking knob (4).
Note:
Loosen locking knob to adjust hand
grip to a comfortable working position,
retighten locking knob.
Assemble Chute
1. Align lower section (7) with middle
section (6). (Dia.3)
2. Slide middle section (6) over lower
section (7), ensure inner divider slots
correctly into groove of lower section
(7). (Dia.3)
Assemble Chute to Motor Section
1. Align complete chute section (6) with
motor unit and push into position.
(Dia.4)
Note:
A motor cut-out safety switch is
located inside top section of motor. To
ensure starting, chute must be firmly
located before finally locking into position.
2. Attach the suction pipe to the motor
housing using the two included screws
(Dia.5)
Attention:
The device may only be
switched on with the 2 parts of the pipe
being firmly connected to each other and
firmly screwed to the motor housing.
Assemble collection bag
1. Position collar section of collection bag
(8) up to collar of motor section.
(Dia.6)
2. Push the bag collar upwards and
locate guide lugs on the inside of the
collar in guides on motor unit, push up
