10-1
5 - DASH / AUT
O
SECTION 10 SLIDEOUT / LEVELING
GENERAL SLIDEOUT /
LEVELING WARNINGS
•
Do not use the coach leveling system as a lift
for changing tires or working under the
vehicle.
•
Never check for hydraulic fluid leaks using
your hands and/or any other body part. The
leaking fluid is under pressure and is capable
of cutting and penetrating your skin, resulting
in severe injury.
•
When extending the rear stabilizers, do not lift
the wheels beyond ground contact. This
overrides the braking effect of both the
transmission’s park and the parking brake.
Without this braking, it is possible for the
vehicle to roll unexpectedly forward (or
backward) off the jacks. This could cause
severe injury or death.
•
Holding a control switch in the “extend” or
“retract” position for a time period longer than
necessary to fully extend or retract the
hydraulic cylinders, can cause overheating
and damage to the pump motor as well as the
electrical components.
•
Do not use the leveler as an emergency brake.
They are not designed for any type of vehicle
braking purpose.
Do not use the levelers on icy or slick surfaces
on which the foot pads may slip.
In The Event Of Accidental Extension
1. Bring the vehicle to a safe and complete stop
as soon as possible.
2. Turn the leveling systems power switch on
and press the all up switch.
3. Visually inspect the vehicle undercarriage for
any problems.
SLIDEOUT ROOM OPERATION
The slideout living room provides a spacious
living area at the push of a button. The slideout
room is extended and retracted using a motorized
mechanism with an electronic control system.
The DigiSync slideout room system uses a
digitally synchronized 12-Volt DC motorized
room mechanism to insure smooth operation and
positive weather seal.
The slideout control switch is located near the
OnePlace monitor panel.
Note: We recommend that you KEEP THE
ENGINE RUNNING WHILE
EXTENDING OR RETRACTING
SLIDEOUT ROOMS so the engine
alternator can provide maximum power
for proper operation of the slideout
mechanisms.
Travel Strap
The travel strap
must be released before
extending the room
or damage to the coach will
result.
The travel strap is designed only to help keep
the room extension secured against the coach
sidewall to maintain an effective weather seal
while the vehicle is in motion. It is not designed
to withstand the force exerted by the room
extension mechanism and will not prevent
accidental extension of the room.
The travel latch is located near the floor at the
front end of the slideout room.
To Release:
•
Pull the strap buckle outward and up to release
tension on strap.
•
Pull a short length of the excess strap back
through the buckle to provide sufficient slack.
