4-5
SECTION 4
APPLIANCES & SYSTEMS
Class A
Please read your Energy Management System
Owners Guide for important information on
running both air conditioner units at the same
time*. This guide will also explain how this
system operates under several conditions,
whether 20-amp, 30-amp or 50-amp connections.
*With 30 amp or optional 50-amp systems only.
PROPANE GAS FURNACE
To Start Up:
1. Open the LP gas tank valve by turning fully
counterclockwise
2. Move THERMOSTAT switch from Off to
Heat and press the Temp Selector button (Up/
Down arrows) until the desired temperature is
shown in the display.
3. Furnace fan should start to blow immediately
after setting the thermostat.
4. After about 30 seconds, the furnace burner
should light.
5. The furnace should now cycle off and on
automatically as the thermostat demands just
like a household furnace.
NOTE:If heat does not come out of the heat
ducts after a minute or so the burner is
not lit.
Turn thermostat off for 3-5 minutes,
check to be sure propane gas tank valve
is open and tank is not empty, then try
steps 2-4 again.
If the furnace will not light after three
attempts, go to Shut Down steps and
contact your dealer or a local RV service
center for repair.
To Shut Down:
1. Slide thermostat switch to Off position.
2. Close propane tank valve if coach will be
stored for a period of time.
For Further Information
Please see the furnace operating instructions
provided in your InfoCase for further
information, including operating precautions,
and periodic maintenance. See the Coach
Maintenance Schedule for recommended
intervals.
NOTE: If the furnace burner has any residuals
of metal protectant or lubricants used
during manufacture of the furnace, it may
smoke slightly when the furnace is used
for the first time and may set off your
smoke alarm.
We recommend that you provide adequate
ventilation when using the furnace for the
first time to avoid a nuisance smoke
EMS Display on Monitor Panel
Thermostat Switch
• Move to Heat or
Gas position for
furnace operation
Temp Selector
• Press up or
down to select
temperature